DEGEN DE1121 Instruction Manual download pdf (Page 13)

FM Mono /Stereo

Normally "Stereo" is selected, if a strong signal without noise is

received.

"Mono" is selected, if too much noise is heard in setting "stereo".

2019

When listening to a FM broadcasting station you can switch

between mono and stereo by pressing FM: Mono/Stereo .

In both modes the main display shows and in stereo mode

there also appears ST in the small display.

Note: The unit has news/music selecting, with the mono/stereo in

the same place. Mono(News), Stereo(Music).

LISTENING TO THE RADIOLISTENING TO THE RADIO

SSB/CW

1. After turning on the radio,select Step searching mode,and

press < > shortly to enter SW band.

2. Press <SSB Button> shortly until the main display shows

and enter SSB working mode.

3. Turn <Knob> to tune to one frequency of approximate SSB.

4. Turn <SSBFINE Knob> slowly to have the best reception.

Narrow/Wide Band

Press AM: W/N button repeatedly to select wide band or narrow

band when listening MM, SW or LW broadcasting.

In AM band, press W/Nbutton short to switch between

Wide and Narrow .

Wide band has a better tone reception than narrow band, but it

is noiser than narrow band reception.

Local-Nor-DX Selectivity

By selecting LO-NOR.-DX the unit can be tuned perfectly to the

particular listening.

Nor: For normal use.

Local: You should change to LO if you want to listen to a

local broadcast station or if there is a strong interference

while listening.

DX: If you want to listen to a broadcast station with a very weak

signal, please change to DX.

LW/MW

NOR

LO-NOR.-DX

Antenna Attentuator

-15dB

-30dB

-25dB

0dB0dB

-3dB

0dB

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

DEGEN DE1121 Instruction Manual Page 13

Comments to this Manuals

Related products and manuals for Receiver DEGEN DE1121